Installing the current distributor
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following spare parts must be installed again:
Hexagon nut M 6, 7 pieces
Hexagon nut M 8, 2 pieces
Service label, red
Depending on condition, flange seal current distributor/firewall
Tie-wraps
CURRENT DISTRIBUTOR INSTALLATION PROCEDURE
| No. | Procedure | Instructions |
|---|---|---|
| 1 | Connecting the connection lines | Connect the connection lines -C--B-9- . See Fig 1 . |
| 2 | Closing and sealing the current distributor | Close the cover until both locking elements -arrow-8-red- . See Fig 1 . |
| 3 | Installing the current distributor | Check the flange seal between the current distributor and the firewall for damage and replace, if necessary. Push the current distributor -A-direction of the arrow-A-6-7- . See Fig 1 . |
| 4 | Screwing the current distributor tight | Tighten both hexagon nuts -3-2-1- . See Fig 1 . |
| 5 | Cover in passenger's footwell | Position the cover -5-4- . See Fig 1 . |
| Connecting the battery | Refer to WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY | |
| Installing the cowl panel cover | Refer to REMOVING AND INSTALLING COWL PANEL COVER . |