LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Wiring - 911 CARRERA (996)) >> Optical fiber (LWL) - MOST Bus >> Removing and installing optical contacts >> Removing and installing optical contacts on connector side >> Notes

Removing and installing optical contacts on connector side: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the secondary locking with the press-out tool. Insert the tool in the opening provided and lift the locking. The locking engages in the upper position. See TOOLS  .
    Fig 1: Opening Secondary Locking
    G03063735Courtesy of PORSCHE OF NORTH AMERICA, INC.
  2. Place the tool on the primary locking and lift the locking.
    Fig 2: Placing Tool On Primary Locking
    G03063736Courtesy of PORSCHE OF NORTH AMERICA, INC.
    • -A-  Optical contact, grey. See Fig 2 .
    • -B-  Optical contact, black. See Fig 2 .
  3. Pull LWL, e.g., -B-  carefully in the -direction of the arrow-  . If it is not possible to pull out the LWL, check again if the secondary locking is completely released and if the primary locking is raised sufficiently. See Fig 2 .
    • Visual inspection of lockings, connector housing, and contacts for possible damage and if necessary, exchange the damaged parts.
scientia non olet · About LEMON Manuals