Allocation of free fuse connection points
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Additional loads must not be connected to the existing free fuse locations in the fuse box.
One exception is fuse D 10, see wiring diagram, connection point retrofit max. 5 A.
The load on the fusible elements in the current distributor was carefully set during development. Connecting additional loads could lead to an overload in the current distributor or to disturbances in the vehicle electrical system.
If an external load should nevertheless be installed subsequently, this must be connected directly to B+ with corresponding fuse protection (line fuse). Cables can be routed into the passenger compartment through the service opening in the firewall (closed off by a rubber sleeve behind the battery) with corresponding sealing.