Installing Cover For Front Middle Backrest

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Place cover on the seat surface and plug in the plug connections for backrest seat heating -1- (-arrows- ).

Fig 1: Connecting Plug Connections
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Make sure that the connections are plugged in fully.
Lock the intake plenum.
1. 2.1. Fold up cover -1- (-arrow A- ).
2. 2.2. Press intake plenum -2- into the air duct -3- (-arrow B- ) until the locking lugs lock with an audible click.
Fig 2: Locking Intake Plenum Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure front cover.
1. 3.1. Press in cover -1- in the middle -arrows A- until the locking lugs at the side engage.
2. 3.2. Engage cover -1- at the top of the backrest frame -2- (-arrow B- ).
Fig 3: Securing Front Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure cover at the back.
1. 4.1. Press cover -1- into the backrest shell -2- at the bottom using a plastic wedge -3- (-arrows- ) until it locks with an audible click.
Fig 4: Securing Cover At Back
Courtesy of PORSCHE CARS NORTH AMERICA, INC.