LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (74 - Seat UPHOLSTERIES, Cover -- CARRERA (997)) >> WM 741919 Removing And Installing Cover For Front Backrest (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 Turbo S CABRIO "Ed. 918 SPYDER", 911 CARRERA 4 GTS CABRIO, 911 Gt3 RS 4.0) >> Subsequent Work >> Removing Creases In Seat Cover (Leather)

Removing Creases In Seat Cover (Leather)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Risk of damage to cover if excessive heat is applied.
  • Creases in cover

→ If creases have formed, only short partial warming with the hot-air gun is permissible.

→ The hot-air temperature of 50 °C must always be observed.

  1. If creases have formed, partially heat the affected areas of the cover with the hot-air gun and smooth out the cover using the special tool.

    Wetting-off iron 9747 

    Knurling iron 9747/1 

    Bone burnisher 9747/2 

    Hot-air gun v.a.g 1416 

scientia non olet · About LEMON Manuals