Installing Cover For Front Seat

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Cover For Front Seat Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Place cover -2- on the padding and align with the contour of the padding.
Information
- Fasten cover to the padding, starting from the inside.
- Do this in the following sequence: rear, front.
Use the cushion clip pliers Nr.130 and the cushion clips -1- to connect the integrated metal struts of the padding -3- with the metal struts of the cover strips -4- .

Fig 2: Aligning Contour Cover Of Padding

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Check fastening clip -1- , and replace if necessary.
Position cover strips right and left -2- at the cut-outs provided to the padding and clip into the seat frame -3- .

Fig 3: Clipping In Cover Strips

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fit cover over the padding without creases.
Fit cover piping -1- all around the seat frame with a plastic wedge.

Fig 4: Fitting Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit cover piping at the rear on the seat frame using a plastic wedge -arrows- .

Fig 5: Fitting Cover At Rear
Courtesy of PORSCHE CARS NORTH AMERICA, INC.