LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (74 - Seat UPHOLSTERIES, Cover -- CARRERA (997)) >> WM 741019 Removing And Installing Padding For Front Seat (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 Turbo S CABRIO "Ed. 918 SPYDER", 911 CARRERA 4 GTS CABRIO, 911 Gt2 RS, 911 Gt3 RS 4.0) >> Installing Padding For Front Seat >> Checking Seat Following Removal

Checking Seat Following Removal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the removed seat to the vehicle's wiring harness via test cable 9745  and test cable 9745/1  .
  2. Connect electric plug to control module trim panel. → INSTALLING CONTROL MODULE TRIM PANEL
  3. Connect the battery. → 2706IN IN -WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
  4. Switch on ignition.
  5. Carry out a function check on the seat components.
  6. Switch off ignition after function test and disconnect battery.
  7. Disconnect test cable 9745  and test cable 9745/1  .
scientia non olet · About LEMON Manuals