Installing Gateway Control Unit

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Push on electric connector until it engages securely on the gateway control unit.

Fig 1: Installing Electric Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check the seal on the cover and replace seal or cover and seal if necessary.

Fig 2: Identifying Cover Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide the gateway control unit into the cover -B- and clip it in -A- .

Fig 3: Installing Gateway Control Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit the cover and secure with the three fastening screws -1- .

Fig 4: Installing Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
If a new gateway control unit has been installed, it must be coded on the vehicle. → Coding Gateway Control Unit