Check With The Temperature Probe
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The function of the heated rear window can be checked using a temperature probe with digital display.
Temperature probe Nr.164 Pos.1
The tip of the sensor is used to measure from the outside on the center of the rear window.
Information
- The heating wire on the rear window must run exactly under the tip of the sensor for this measurement procedure!
- After switching the heating on at room temperature and after a period of 2 minutes, the temperature must increase by approx. 2 degrees!
- If no temperature increase is shown, the fault must be detected on the basis of the wiring diagram!