LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (64 - Glazing, Window Control -- CARRERA (997)) >> WM 647119 Removing And Installing Rear Window Lifter (911 CARR. CABRIO, 911 CARR. S CABRIO, 911 CARR. GTS CABRIO, 911 CARRERA CABRIO Black Edition, 911 CARR. CABRIO "Edition Style", 911 CARR. 4 CABRIO, 911 CARR. 4S CABRIO, 911 Turbo CABRIO, 911 Turbo S CABRIO) >> Installing Rear Window Lifter >> Notes

Installing Rear Window Lifter: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Position Of Rear Window Lifter
G09826632Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Connect electric plug connection -1-  to the window regulator motor -2-  (-arrow A-  ) and lock the latch -3-  (-arrow B-  ).
  2. Guide power windows mechanism -4-  into the window shaft from above -arrow C-  and position it in the mounts in the inner side section.
    3. Fig 2: Installing Power Windows
    G09826633Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Remove spacing block -1-  between the B-pillar and convertible top support -2-  (-arrow A-  ). Position convertible top support -2-  (-arrow B-  ). Position and tighten fastening screws -3-  and fastening nuts -4-  in the convertible top support -2-  . → Tightening torque: 23 Nm (17 ftlb.) 
    Fig 3: Securing Convertible Top Support
    G09826634Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Insert the deflection fitting -5-  into the belt guide section mounting -arrow C-  . Screw in and tighten fastening screws -6-  . → Tightening torque: 50 Nm (37 ftlb.) 
scientia non olet · About LEMON Manuals