Installing Hydraulic Cylinder

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Position For Hydraulic Cylinder

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position hydraulic cylinder -6- with the drive lever on the convertible top support. Insert potentiometer fork into the bolt on the hydraulic housing (on the left side only).
Route hydraulic line Fig 2 into the clamp under the water drain hose. In Fig 2 and Fig 2, press the hydraulic lines into the clips. Tighten fastening nuts -5- . → Tightening torque: 17 Nm (13 ftlb.)+/-2 Nm (+/-1.5 ftlb.)

Fig 2: Installing Hydraulic Cylinder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit drive lever -2- and secure with retaining clip -1- .

Fig 3: Installing Drive Lever
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert splash guard -3- into the chamber in the water drip pan -4- .

Fig 4: Installing Splash Guard
Courtesy of PORSCHE CARS NORTH AMERICA, INC.