Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening screws and fastening nuts in convertible top support | M8 | Tightening torque | 23 Nm (17 ftlb.) | ||
| Fastening screw for securing deflection fitting in belt guide section | M8 | Tightening torque | 50 Nm (37 ftlb.) | ||
| Upper edge molding of rear side section to side window | Front | Gap dimension C | 11 mm | ||
| Upper edge molding of rear side section to side window | Rear | Gap dimension D | 14 mm | ||
| Side window to door window | Gap dimension E | 9 mm | +/-1 mm | ||
| Adjusting elements for door window | Tightening torque | 17 Nm (13 ftlb.) | |||
| Fastening screws (M6) on rear window inner seal | Tightening torque | 10 Nm (7.5 ftlb.) |