LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (64 - Glazing, Window Control -- CARRERA (997)) >> WM 647119 Removing And Installing Rear Power Windows Mechanism (911 Speedster) >> Installing Rear Power Windows Mechanism

Installing Rear Power Windows Mechanism

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install power windows mechanism.
    1. 1.1. Connect electric plug connection -1-  to the window regulator motor -2-  (-arrow A-  ) and lock the latch -3-  (-arrow B-  ).
    2. 1.2. Guide power windows mechanism -4-  into the window shaft from above -arrow C-  and position it in the mounts in the inner side section.
    Fig 1: Installing Power Windows Mechanism
    G09826650Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Secure the convertible top support.
    1. 2.1. Remove spacing block -1-  between the B-pillar and convertible top support -2-  (-arrow A-  ).
    2. 2.2. Position convertible top support -2-  (-arrow B-  ).
    3. 2.3. Position and tighten fastening screws -3-  and fastening nuts -4-  in the convertible top support -2-  . → Tightening torque: 23 Nm (17 ftlb.) 
    4. 2.4. Insert the deflection fitting -5-  into the belt guide section -arrow C-  .
    5. 2.5. Screw in and tighten fastening screws -6-  . → Tightening torque: 50 Nm (37 ftlb.) 
    Fig 2: Securing Convertible Top Support
    G09826651Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals