LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (64 - Glazing, Window Control -- CARRERA (997)) >> WM 647119 Removing And Installing Rear Power Windows Mechanism (911 Speedster) >> Additional Instructions For Adjusting Or Replacing The Rear Power Windows Mechanism >> Additional Instructions For Adjusting Or Replacing The Rear Window Lifter

Additional Instructions For Adjusting Or Replacing The Rear Window Lifter

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

The rear power windows can be operated if:

1) the convertible top is closed.

2) the ignition is switched on.

3) the ignition key is not removed from the steering lock after the ignition is switched off.

4) after the ignition is switched off until a door is opened for the first time.

5) the door is open, USA vehicles do not have this function.

Information 

The end positions of the power windows are deleted from the control unit when the electric connectors are disconnected and connected.

Standardizing the system

  1. Actuate rocker switch and fully close window once.
  2. Set rocker switch to Close again. The upper end position of the side window is stored.
  3. Actuate rocker switch and fully open window once.
  4. Set rocker switch to Open again. The lower end position of the side window is stored.

Blockage detection function

If the window drive encounters resistance when activated, the motor is switched off after a delay of 500 ms. If the rocker switch is pressed again within 10 seconds, the side window closes with all of its power windows closing force. Anti-pinch protection is deactivated.