Pre-Treating Bonded Flanges On The Vehicle Body
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The table below shows how to use cleaners, primers and activators when preparing the bonding surfaces.
| Prepare vehicle window flange for installation | ||
|---|---|---|
| Old flange (old paint) | New flange (new paint) | |
| Cut back adhesive bead ? |
Cleaner ? |
|
| Clean flange surface ? |
||
| Activator ? |
Primer ? |
|
| Activate adhesive bead (only necessary after standing times > 24 h) ↓ |
Prime flange surface ? |
|
| Apply adhesive | ||
| Install glass | ||