Pre-Treating Adhesive Flanges On Vehicle Windows
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The table below shows how to use cleaners, primers and activators when preparing the bonding surfaces.
| Preparing vehicle windows for installation | ||
|---|---|---|
| Old glass | New glass | |
| (window removed) | with preliminary coat (durable primer) | |
| Cut back adhesive bead ? |
Cleaner ? |
|
| Clean rim (ceramic layer and durable primer) ? |
||
| Activator ? |
Primer ? |
|
| Activate adhesive bead (only necessary after standing times > 24 h) ↓ |
Apply primer from the adhesive kit over the durable primer on the spare part ? |
|
| Apply adhesive | ||
| Install glass | ||