Removing Adhesive From The Body
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The surface coating of adhesive residue on the window aperture of the body acts as an adhesive base for new bonding material. Keep cut surfaces clean and free of grease and do not clean with cleaning solution.
- When removing remaining adhesive -2- with the cutting tool -C- and the flashing knife -D- on the body, ensure that a surface coating of adhesive remains -3- .
Cleaning And Priming Areas That Are Free Of Adhesive Residue Or Have Paint Damage Or Where There Is Newly Built-Up Paint In The Window Aperture Of The Body
Information
- A flash-off time of at least 2 minutes must be observed between the cleaning of the window aperture and the application of the primer! No cleaning solution residues must remain on the body.
- Clean areas that are free of adhesive residue or have new paint or where there is damage to the top coat paint in the non-visible area of the window aperture in the body with cleaning solution -H1- and touch up with primers -H2- .