Inserting Windscreen Into The Body
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Danger of material damage if specified curing time of adhesive is not observed!
- There will not be a proper adhesive bond if the prescribed curing time of the adhesive is not observed!
→ The vehicle must not be used until the curing time has elapsed.
→ Curing time: 3 hours
→ Temperature: at least 10°C
→ Fixing time: approx. 1 hour
Information
- Two persons are needed to insert and adjust the windscreen.
Information
- The rear window can no longer be aligned, because the bonding section on the seal immediately sticks to the body when the rear window is installed.
- Guide the windscreen -5- into the window aperture and insert in the pre-marked positions.