Guiding Cutting Thread Into The Passenger Compartment
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- In order to prevent damage, make sure that the vehicle identification number is completely covered by the protective film when pushing through the adhesive bead.
- Warm awl beforehand with the hot-air gun for pushing this through.
- Push through adhesive bead on the glass on the edge of the vehicle identification number -C- with the awl -A4- from the inside to the outside.
- Pass cutting thread -B- through the eyelet on the awl -A4- .
- Pull cutting thread -B- into the passenger compartment.
- Pull cutting thread -B- out of the awl -A4- .
- Draw cutting thread -B- approx. 1m into the passenger compartment.