LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (64 - Glazing, Window Control -- CARRERA (997)) >> WM 6400IN General Information On Installing And Removing Car Windows (911 CARR. Coupe, 911 CARR. S Coupe, 911 CARR. CABRIO, 911 CARR. S CABRIO, 911 CARR. 4 Coupe, 911 Turbo Coupe, 911 CARR. 4S Coupe, 911 TARGA 4, 911 TARGA 4S, 911 CARR. 4 CABRIO, 911 CARR. 4S CABRIO, 911 Turbo CABRIO, 911 Gt3, 911 Gt2, 911 Gt3 RS) >> Removing Glass With Cutting Wire Separator >> Attaching Cutting Thread To The Body

Attaching Cutting Thread To The Body

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the loose end of the cutting thread -B-  firmly at a suitable point on the body with the fastening screw -2-  of a component (e.g. wiper motor fastening). To do this, unscrew the fastening screw, wind the cutting thread -B-  around the screw and tighten the fastening screw again.
    Fig 1: Attaching Cutting Thread To Body
    G09826483Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals