Removing and installing actuating element for lid release

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Remove handle liner.
Remove bracket with actuating elements.
Unscrewing fastening screws.

Fig 1: Removing/Installing Actuating Element For Lid Release Screws
Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE: Electrical locking of the rear lid release has been omitted on vehicles manufactured after March `99. Front lid release locking is still carried out electrically.

Electric locking is carried out by the alarm system control module and is valid for the following country codings: USA, England and Belgium