Installing Control Unit For Rear Convenience Systems

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Insert control unit into holder making sure the clips engage.

Fig 1: Clipping Control Unit Into Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press electric connectors into control unit until they are felt to engage.

Fig 2: Pushing On Electric Connectors
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Turn the holder through 180° into the direction of travel, engage at front and clip in at rear.

Fig 3: Clipping In Holder For Control Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
If a new control unit has been installed, continue under → Programming Control Unit For Rear Convenience Systems ; → Coding Control Unit For Rear Convenience Systems