Installing wiper motor

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Carefully raise the wiper link and position the wiper motor from below.

Fig 1: Positioning Wiper Motor From Below
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push electrical connector onto wiper motor until it is felt to engage.
Secure the wiper motor with the three fastening screws -2- to the wiper link. → Tightening torque: 6 ftlb.

Fig 2: Screwing Down Wiper Motor To Wiper Link
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw down the fastening screw -3- for the wiper link. → Tightening torque: 7.5 ftlb.
Connect battery, ignition on, and actuate wiper motor.
Allow wiper motor to run in parking position. Place the link on the drive on the wiper motor. Place fastening nuts -1- . The installation position of the link is identified by a 0 marking (parking position) on the console.

Fig 3: Identifying Installation Position For Wiper Motor Drive
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
If the position -0- matches, then screw down the fastening nut -1- . → Tightening torque: 13 ftlb.
Connect the battery.
Switch on the wiper motor and check the wiper position.