Removing Motor For Rear Vertical Adjustment

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Position Of Motor For Rear Vertical Adjustment

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pull connector -1- off the motor for rear vertical adjustment -3- .

Fig 2: Removing Motor For Rear Vertical Adjustment
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew the two fastening screws -2- and remove motor for rear vertical adjustment -3- .
Pull drive shaft -1- out of the gear mount -2- and check for damage.

Fig 3: Removing Drive Shaft
Courtesy of PORSCHE CARS NORTH AMERICA, INC.