Installing Locking Mechanism For Rear Backrest

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Position lock for backrest -5- on the backrest frame -arrow A- and screw in the fastening screws -4- . Tightening torque → Tightening torque: 12 Nm (9 ftlb.)+/-2 Nm (+/-1.5)

Fig 1: Installing Lock
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clip in cover -3- .
Press in reset spring -2- until it engages -arrows B- and check lever function.
Press connection for backrest cover -2- sideways into the backrest frame with a plastic wedge -arrows A- .

Fig 2: Securing Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press in protection washer -1- (-arrow A- ).
Position cover for lock -2- and screw in the fastening screws -1- .

Fig 3: Installing Cover For Lock
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Place collar -3- in position and screw in the fastening screws -1- .

Fig 4: Installing Control Button
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press in control button -2- .