Removing Control Valve For Air Cushion

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Position Of Control Valve For Air Cushion

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unscrew the two fastening screws -1- on the holder -2- .

Fig 2: Loosening Holder With Air Distribution Valve
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Set holder -2- with connected air cushion control valve aside.
Release connector -1- on air cushion control valve -arrow a- and pull it off.

Fig 3: Pulling Off Connector And Hoses On Air Cushion Control Valve
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull the three hoses -2- off the air cushion control valve.
Unscrew fastening screw -1- and remove air cushion control valve -2- .

Fig 4: Removing Control Valve For Air Cushion
Courtesy of PORSCHE CARS NORTH AMERICA, INC.