Installing Control Valve For Air Cushion

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Position air cushion control valve -2- and tighten with the fastening screw -1- .

Fig 1: Installing Control Valve For Air Cushion
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Observe the installation position of the hoses!

Push on the blue hose onto the connection marked B and push on the red hose onto the connection marked R .
Push the three hoses -2- onto the air cushion control valve.

Fig 2: Pushing Connector And Hoses Onto Air Cushion Control Valve
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push connector -1- onto the air cushion control valve until it engages securely.
Position holder -2- with connected air cushion control valve and secure with the two fastening screws -1- .

Fig 3: Securing Holder With Air Distribution Valve
Courtesy of PORSCHE CARS NORTH AMERICA, INC.