Installing Lumbar Support: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install the lumbar support -1- together with the red and blue hose -3- .

Fig 1: Installing Lumbar Support
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure the lumbar support -1- to the grille using two new tie-wraps -2- .
Information

Only for seats with a memory function
Attach connectors to the lumbar support sensors.

Fig 2: Attaching Connectors To Lumbar Support Sensors
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Observe installation position of connectors!

Push red-lilac-brown connector onto the sensor at the top air cushion.

Push red-white-brown connector onto the sensor at the bottom air cushion.
1. 3.1. Connect the two connectors -3- to the sensors -2- (-arrow A- ) until they engage securely.
2. 3.2. Push the two sensors -2- behind the backrest panel -arrows B- and fold down the lumbar support -1- (-arrow C- ).
Lay the red hose and the blue hose -1- on the backrest frame -2- .

Fig 3: Laying Hoses On Backrest Frame
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Observe the installation position of the hoses!

Push on the blue hose onto the connection marked B and push on the red hose onto the connection marked R .
Slide the red and blue hose -1- onto the lumbar support control valve -2- .

Fig 4: Sliding Hoses Onto Lumbar Support Control Valve
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check the function of the lumbar support using the test cable.