Fitting Foam Part

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Observe the installation position of the hoses!

Make sure that the hoses are not pinched. Insert hoses exactly into the cut-outs on the foam part.

Fit foam part -1- at the headrest.

Fig 1: Fitting Foam Part
Courtesy of PORSCHE CARS NORTH AMERICA, INC.