LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (72 - Seat Frames -- CARRERA (997)) >> WM 722519 Removing And Installing BOWDEN Cable For Backrest Release (Except Turbo S Coupe "Ed. 918 SPYDER", CARRERA 4 GTS, Turbo S CABRIO "Ed. 918 SPYDER", CARRERA 4 GTS CABRIO, Gt3 RS 4.0) >> Removing Bowden Cable For Backrest Release >> Notes

Removing Bowden Cable For Backrest Release: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release backrest and tilt forwards.
  2. Swivel pin -2-  of bowden cable -1-  up by 90° -arrow A-  and disengage it -arrow B-  .
    Fig 1: Disengaging Bowden Cable Upwards
    G09829644Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Press locking tab on fixing clip -3-  outwards slightly and press fixing clip -3-  down and out with a plastic hammer -arrow C-  .
  4. Swivel eye -2-  of bowden cable -1-  by 90° -arrow A-  and pull it out of the locking lever.
    Fig 2: Disengaging Bowden Cable Downwards
    G09829645Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Unclip fixing clip -3-  from the backrest frame -1-  (-arrow B-  ).
  6. Pull bowden cable -1-  up out of the backrest frame -arrows C-  .
scientia non olet · About LEMON Manuals