LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (72 - Seat Frames -- CARRERA (997)) >> WM 721955 Replacing Backrest Frame (Except Turbo S Coupe "Ed. 918 SPYDER", CARRERA 4 GTS, Turbo S CABRIO "Ed. 918 SPYDER", CARRERA 4 GTS CABRIO, Gt3 RS 4.0) >> Disassembling Backrest Frame >> Disconnecting Wire Harnesses On Backrest Frame

Disconnecting Wire Harnesses On Backrest Frame

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Only for vehicles with lumbar support.

Information 

Make sure not to trap or damage the wire harness when pulling it through.

  1. Pull wire harness for backrest -1-  down out of the backrest frame -2-  .
    Fig 1: Pulling Out Wire Harness For Backrest
    G09829575Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Turn plug connection -1-  approx. 90° anti-clockwise -arrow A-  and pull it off the backrest frame -arrow B-  .
    Fig 2: Disconnecting Plug Connection
    G09829576Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Release plug connection -arrows C-  and disconnect it -arrows D-  .

    Information 

    Make sure not to trap or damage the wire harness when pulling it through.

  4. Press locking tabs on fixing clip -2-  together and unclip it -arrow E-  . Pull wire harness for backrest -3-  down and out -arrow F-  .
  5. Press locking tabs on fixing clip -2-  together and unclip wire harness for side airbag -4-  from the backrest frame -arrow G-  .
scientia non olet · About LEMON Manuals