Securing Wire Harnesses On Backrest Frame

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Only for vehicles with lumbar support.

Information

Make sure not to trap or damage the wire harness when pulling it through.

Pull wire harness for backrest -1- up into the backrest frame -2- .

Fig 1: Pulling Through Wire Harness For Backrest
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press fixing clip -2- on wire harness for side airbag onto the backrest frame -arrow A- .

Fig 2: Securing Wire Harness For Backrest
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Make sure not to trap or damage the wire harness when pulling it through.
Pull wire harness for backrest -3- through -arrow B- and press in fixing clip -2- (-arrow C- ).
Push plug connection -1- together -arrows D- until it engages securely.
Insert plug connection -1- into the backrest frame -arrow E- and turn it clockwise by approx. 90° -arrow F- .