Removing Control Part Trim Panel

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Location For Control Part Trim Panel

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unscrew front fastening screws 1 from the control part trim panel 2 .

Fig 2: Unscrewing Front Fastening Screw
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew rear fastening screws 1 from the control part trim panel 2 .

Fig 3: Unscrewing Rear Fastening Screw
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull out control part trim panel 2 from the cushion in direction of arrow.

Fig 4: Pulling Out Control Part Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect electric plug connection 3 and 4 , unscrew fastening screws 5 from the tip switch 6 and take off the tip switch from the control part trim panel 2 .

Fig 5: Disconnecting Electrical Plug Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.