Installing Control Part Trim Panel

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Position tip switch 6 on the control part trim panel 2 and screw down with the fastening screws 5 . Plug in electrical plug connection 3 and 4 .

Fig 1: Connecting Electrical Plug Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert control part trim panel 2 into the cushion in direction of arrow.

Fig 2: Positioning Control Part Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw down rear control part trim panel 2 with the fastening screws 1 . → Tightening torque: 2 ftlb.

Fig 3: Screwing Down Rear Control Part Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw down front control part trim panel 2 with the fastening screws 1 . → Tightening torque: 2 ftlb.

Fig 4: Screwing Down Front Control Part Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.