LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (72 - Seat Frames -- CARRERA (997)) >> WM 720119 Removing And Installing Front Seat (Except Turbo S Coupe "Ed. 918 SPYDER", CARRERA 4 GTS, Turbo S CABRIO "Ed. 918 SPYDER", CARRERA 4 GTS CABRIO, Gt3 RS 4.0) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Incorrect information for the AWS control unit
  • Passenger's airbag is triggered incorrectly

→ Calibrate the AWS control unit if the passenger's seat was removed and re-installed, or if the seat bracket or AWS control unit was replaced.

→ Do not loosen the safety screws on the AWS sensors or seat frame.

→ Only replace retainer plate for seat adjustment motor on vehicles without AWS sensors.

→ Always replace the retainer plate together with the seat frame on vehicles with an AWS sensor.

Information 

  1. Calibrate the AWS control module. → 6968K2 CALIBRATING AWS CONTROL MODULE