Fastening Electric Line

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Front Seat

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

NOTE: Incorrect line routing

Risk of damage to lines and hoses
Malfunction and fault memory entry on control unit

→ Avoid small bending radii when routing lines.

→ File down edges and burrs in the routing area or mask them with adhesive tape.

→ Maintain a sufficient distance from components exposed to high temperatures while driving.

Information

The routing of the wire harness for the control unit must be checked before installing the seat.

Fig 2: Routing Of Wire Harness

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

The wire harness must not be routed over the cover, but should be laid along side the cover -A- .

Information

Before installing and securing the front seat, make sure the electric lines are not pinched or damaged.

Place front seat in car and tilt backwards.

Fig 3: Locating Fastening Electric Line
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check tie-wrap -1- , replace tie-wrap -1- if necessary.
Clip wire harness -2- into place.