Installing Cover Strip

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Cover Strip Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

The bonding surface must be free of dirt and grease. Clean with cleaning solution if necessary.

Pull protective film off the bonding area of cover strip.

Fig 2: Pulling Off Protective Film
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position cover strip and apply. Centre notch in cover strip at height of bead.

Fig 3: Installing Cover Strip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press on cover strip firmly.