Installing CD Changer

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

If a new CD changer is installed, the adjusting screw must be in position V .

Fig 1: Identifying Adjusting Screw Position Of CD Changer

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Place the retaining frame onto the threaded pins and screw down using the three fastening nuts -2- . → Tightening torque: 6.5 Nm (5 ftlb.)

Fig 2: Installing Retaining Frame Fastening Nuts
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Plug the electric connectors into the CD changer until they are felt to engage.
Insert the CD changer into its retaining frame and screw down tight with the six fastening screws. → Tightening torque: 2.5 Nm (2.0 ftlb.)

Fig 3: Installing Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.