Re-Programming CDR 30
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Programming interrupted
- Malfunctions in control unit
- Risk of damage to control unit
→ Before starting work, connect a suitable battery charger with a current rating of at least → Nominal value: 40 A to the jump-start terminals in the engine compartment.
- Switch on ignition.
- Switch on CDR 30 and press the [CD AUX] button.
- Load the Update CD into CDR 30:
- 3.1. Press the [CD symbol] button and select an empty CD slot ([CD 1 - 6]).
- 3.2. If there is no empty CD slot, eject the CD in slot 1 by pressing the [CD 1] button.
- 3.3. Insert the Update CD into CDR 30.
- Confirm the selection menu for starting the CDR 30 update by selecting "Yes".
The modules are downloaded automatically from the Update CD.
A progress bar appears in the display showing how the download is progressing from 0% to 100%.
The following messages appear when the download is 100% complete:
==> "Software download on device CDR 30 check - please wait"
==> __CDR 30__ successful
... Modules done
- Confirm "OK" in the display by pressing the right rotary knob.
If the message "Error - CD unreadable" appears in the display, please ignore this message.
- Eject the Update CD.
- Switch off ignition and disconnect the battery charger from the vehicle.
End of remedial action.