LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (91 - Radio, Telephone, On-Board Computer, Navigation -- CARRERA (997)) >> WM 911719 Removing And Installing TV Tuner (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 Turbo S CABRIO "Ed. 918 SPYDER", 911 CARRERA 4 GTS CABRIO, 911 Gt3 RS 4.0) >> Programming TV Tuner >> Coding TV Tuner

Coding TV Tuner

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Voltage drop
  • Risk of irreparable damage to control unit
  • Risk of damage to control unit
  • Fault entries in the control unit
  • Coding in the control unit is aborted
  • Malfunctions in control unit, even during programming

→ Prior to disconnecting the control unit, switch off ignition and remove ignition key.

→ Ensure that the power supply is not interrupted during programming.

→ Connect a battery charger with a current rating of at least → Nominal value: 40 A  to the vehicle battery.

Information 

The PIWIS Tester II 9818  instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms; different text or additions may appear in PIWIS Tester II 9818  .

Information 

The procedure described must be applied when a control unit has to be replaced and the tester function Control unit replacement  cannot be used.

  1. PIWIS Tester II 9818  must be connected to the vehicle and ignition switched on.
  2. Select the vehicle type  and start the PIDT.
  3. Carry out an automatic control unit search.
  4. Press [F12] to switch from the vehicle type to the list of control units.
  5. Select TV tuner  and Coding/adaptation  with the cursor keys and press [F12].
  6. In the Coding/adaptation  menu, the coding values must be adapted according to the vehicle equipment, configurations or country-specific variants.
    1. 6.1. Select Video standard AV input  PAL or NTSC (depending on the country) and press [F12] to confirm your selection. Then press [F8] to start coding.
    2. 6.2. Set Rear Seat Entertainment video/audio output  to inactive or active (depending on vehicle model and vehicle equipment) and press [F12]. Then press [F8] to start coding.
    3. 6.3. Set antenna configuration vehicle coding  to 9x7 or Cayenne (depending on vehicle model) and press [>>] to confirm. Then press [F8] to start coding.
    4. 6.4. Select Country setting  , e.g. Northern, Central, Southern or South-Eastern Europe (depending on country) and press [F12] to confirm your selection. Then press [F8] to start coding.
  7. Exit the menu and check the TV function in PCM.
  8. Then read out the fault memory.
scientia non olet · About LEMON Manuals