Removing Wire Harness

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Pump unit
Wire harness
Hydraulic cylinder, left
Hydraulic line, short
Hydraulic cylinder, right
Hydraulic line, long

Fig 1: Overview Of Spoiler Drive (Pump Unit)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lever off the cover on the right hydraulic cylinder at points -a- using a screwdriver -Arrow A- and remove it -Arrow B- .

Fig 2: Removing Micro Switch Cover On Hydraulic Cylinder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw out the fastening screws -1- and remove the holder with the micro switches.

Fig 3: Removing Micro Switches From Hydraulic Cylinder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull the two wire harness connectors -2- off the pump unit -1- and remove the wire harness -2- .

Fig 4: Pulling Off Connectors Pump Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.