Installing Wire Harness

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Pump unit
Wire harness
Hydraulic cylinder, left
Hydraulic line, short
Hydraulic cylinder, right
Hydraulic line, long

Fig 1: Overview Of Spoiler Drive (Pump Unit)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lay the wire harness and connect the two wire harness connectors -2- to the pump unit -1- .

Fig 2: Connecting Connectors To Pump Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Make sure that pins -a- are inserted into the bores -b- .
Insert the holder with the micro switches into the hydraulic cylinder and secure with fastening screws -1- . → Tightening torque: 0.5 Nm (0.5 ftlb.)

Fig 3: Securing Micro Switches On Hydraulic Cylinder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press the cap onto the micro switches until it engages securely.

Fig 4: Fitting Cap For Micro Switches
Courtesy of PORSCHE CARS NORTH AMERICA, INC.