Installing Hydraulic Cylinder

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Pump unit
Wire harness
Hydraulic cylinder, left
Hydraulic line, short
Hydraulic cylinder, right
Hydraulic line, long

Fig 1: Overview Of Spoiler Drive (Pump Unit)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

The short hydraulic line is connected to the left hydraulic cylinder and the long hydraulic line is connected to the right hydraulic cylinder.

Information

Counter at the hydraulic line with an open-ended wrench when tightening the banjo bolt.

Screw hydraulic lines onto the hydraulic cylinders.
1. 1.1. Fit short hydraulic line -2- and long hydraulic line -3- using the long banjo bolts -4- and new sealing rings -5- on the hydraulic cylinder -1- and tighten hand-tight to approx. 1 Nm (0.5 ftlb.).
Fig 2: Removing Hydraulic Lines Onto Hydraulic Cylinders
Courtesy of PORSCHE CARS NORTH AMERICA, INC.