Installing Spoiler Drive: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Spoiler Drive Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Insert the two hydraulic cylinders together with the pump unit. Place hydraulic cylinders in installation position and secure with fastening screws -1- . → Tightening torque: 10 Nm (7.5 ftlb.)

Fig 2: Securing Hydraulic Cylinders For Rear Spoiler
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clip in wire harness.

Fig 3: Clipping In Wire Harness For Rear Spoiler
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect connector on auxiliary brake light. → INSTALLING AUXILIARY HEADLIGHT
Fit pump unit -2- and screw in fastening screws -1- . → Tightening torque: 10 Nm (7.5 ftlb.)

Fig 4: Securing Pump Unit For Spoiler Drive
Courtesy of PORSCHE CARS NORTH AMERICA, INC.