Removing The Rear Logo

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Logo Area

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Heating the rear lid
1. 1.1. Heat the rear lid -1- close to the logo -2- using the hot-air blower v.a.g 1416 -3- .
  
  Fig 2: Heating Rear Lid
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Levering off the logo using a plastic spatula
1. 2.1. Move a plastic spatula -1- under the logo -2- and lift it up.
  
  Fig 3: Levering Off Logo
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clean the rear lid
1. 3.1. Loosen adhesive residue -1- on the rear lid -2- using silicone remover and remove it.
  
  Fig 4: Cleaning Rear Lid
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.