LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (66 - Exterior Equipment -- CARRERA (997)) >> WM 664655 Replacing Gt2 RS Logo (911 Gt2 RS) >> Replacing GT2 RS Logo >> Sticking on GT2 RS Logo

Sticking on GT2 RS Logo

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the surface (door) by washing it with a non-lubricating cleaning agent.
  2. Immediately before you stick on the decorative film, wash off the areas on which you intend to stick the logo using spirits or alcohol to ensure that all traces of silicon, grease and oil are completely removed.
  3. Pull off protective film and position, align and affix the logo -2-  on the door -1-  .

    Use the dimensions (-A= 32 mm-  ) and (-B= 27 mm-  ) as a guide.

    Fig 1: Sticking On GT2 RS Logo Dimension
    G09826909Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Press on the logo using strong, overlapping strokes (plastic spatula).
  5. Check the logo for bubbles and creases. Press the air out of any bubbles you find using the plastic spatula.
scientia non olet · About LEMON Manuals