Disassembling Roof Joint Cover Strip

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Roof Joint Cover Strip Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Insert a screwdriver -1- beneath both ends of the fold-out element -2- and press out.

Fig 2: Removing Fold-Out Element
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull roof frame seal -1- from the roof joint cover strip -2- .

Fig 3: Pulling Off Roof Joint Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Between the roof joint clip -1- and the roof joint cover strip -2- insert a narrow screwdriver -3- and press outwards until the roof joint clip disengages.

Fig 4: Removing Roof Joint Clips
Courtesy of PORSCHE CARS NORTH AMERICA, INC.