LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (66 - Exterior Equipment -- CARRERA (997)) >> WM 663419 Removing And Installing Side-Section Trim (911 CARR. Coupe, 911 CARR. S Coupe, 911 CARR. CABRIO, 911 CARR. S CABRIO, 911 Gt3) >> Installing Side-Section Trim

Installing Side-Section Trim

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Side-Section Trim Position
G09826775Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Check sheetmetal nuts -3-  for deformation, replacing if necessary -3-  .
  2. Insert side-section trim -2-  and push retaining clip -4-  into side panel.
  3. Screw in fastening screws -1-  and tighten to specified tightening torque → : 1.5 ftlb.  .
Fig 2: Installing Side-Section Trim
G09826776Courtesy of PORSCHE CARS NORTH AMERICA, INC.


Fig 1: Identifying Side-Section Trim Position
G09826855Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Check sheetmetal nuts -3-  for deformation, replacing if necessary -3-  .
  2. Insert side-section trim -2-  and push retaining clip -4-  into side panel.
  3. Screw in fastening screws -1-  and tighten to specified tightening torque → : 1.5 ftlb.  .
    4. Fig 2: Installing Side-Section Trim
    G09826856Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals