Removing Rear Wheel Housing Liner - Front Section

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Position Of Rear Wheel Housing Liner

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Fastening nuts cannot be used again following removal.

Unscrew fastening screws -1- and fastening nuts -2- and remove front section of wheel housing liner -A- .

Fig 2: Removing Rear Wheel Housing Liner - Front Section
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check speed nuts -3- and replace them if necessary.