LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (53 - Body Rear - CARRERA (997)) >> WM 536855 Replacing Rear Wheel Housing (All Models) >> Installing Rear Wheel Housing >> Installing Outer Rear Wheel Housing

Installing Outer Rear Wheel Housing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fitting outer rear wheel housing to the body
    1. 1.1. Place the outer rear wheel housing against the body and secure to the straightening set.
    2. 1.2. Fix the outer rear wheel housing in place with tensioning clamps.
  2. Welding in outer rear wheel housing
    1. 2.1. Resistance spot-weld outer rear wheel housing in area -A-  .
      Fig 1: Identifying Welding In Outer Rear Wheel Housing
      G09823609Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Installing side section
    1. 3.1. Only on the Coupe
      1. 3.1.1. Install side section. → 535555 REPLACING SIDE SECTION  - section on "Installing"
    2. 3.2. Only on the Cabriolet
      1. 3.2.1. Install side section. → 535555 REPLACING SIDE SECTION  - section on "Installing"
scientia non olet · About LEMON Manuals